Carver PM 1.75 2 ch magnetic field power amp USED

The 19” extruded aluminum front panel includes handles for ease of installation, separate gain controls for each channel, signal present and clipping indicators for both channels, and the power switch which has a pilot lamp.
The rear panel has:

• both 1/4” phone and XLR connectors for the inputs,
• 5-way binding posts for the outputs, ( banana plugs)
  
• a switch to bridge the amp for mono mode. and

• separate power supply fuses on DCV+ and DCV- for each channel,
• thermal sensing circuits that monitor output device temperature and correspondingly control the DC fan,
• a relay to disengage the load if excessive DC offset is detected or if the output device temperature becomes too high,
• a delay to avoid dangerous turn-on/off transients, and an
• AC line fuse if all else fails.